Advertisement
User instructions
SPREAD HALF LOAD
Suitable when there are not many dishes to be washed, it saves energy
and reduces the program duration. Place dishes in both baskets then
load the detergent dispenser than less than the normal amount for a full
load.
Flexi Tabs
Specifically for washing with combination detergents in tablets, which
also contain salt and rinse aid (3in1) or other agents such as glass
protector, steel rinse aids, etc. (4in1, 5in1...). When this option is
selected, salt and rinse aid will not be dispensed even if the relative
compartments contain them. If the containers are empty, the lights will
remain on.
If the option is not provided, we recommend the use of conventional
products (separate detergent, salt and rinse aid), because with
conventional washing cycles, combined products might create problems
such as a white deposit, poor drying results and residues left on dishes.
For further information, refer to the detergent pack.
IMPORTANT:
when no longer required, the option must be deactivated by pressing
the relative button (the light goes out).
These products are not suitable for use with excessively "hard" water. If
the hardness level set is higher than H3, when the option is activated the
relative light flashes to indicate that the product is being used incorrectly;
the dishwasher will still work, but washing results may be poor.
PROGRAM DELAY
The PROGRAM DELAY button can be pressed to delay the start of the
washing program by from 1 to 12/24 hours depending on the model. This
option allows the dishwasher to be operated at the time of day of the user's
choice. The first time the PROGRAM DELAY button is pressed the option
light comes on and 1:h appears on the DISPLAY (9). The button can then
2:h, 3:h
be pressed again, to set the delay required (
, ... etc.). If no button
is pressed for a few seconds, the DISPLAY (9) shows the time left (time
5:40
remaining) to the end of the selected program (e.g.
, duration of the
washing cycle + program delay). When the user confirms the program start
(read the relative section) a prewash will be carried out, after which the
PROGRAM DELAY set will begin, and the time remaining on the DISPLAY
will gradually be counted down. At the end of the delay set, the option light
goes out and the washing cycle starts.
N.B.: It is not possible to select the PROGRAM DELAY option once the
cycle has begun.
14
Advertisement
