Table of Contents
Advertisement
Troubleshooting:
All lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of the product, follow the
guide below for troubleshooting and repair information. If the problem cannot be rectified using the solutions given below, additional information may be
obtained from the manufacturer – contact details are at the end of this document.
PROBLEM
Does not function
Incorrect flash patterns
!
NOTE:
Operating the vehicle without the outer lens installed on the product may result in damage that will NOT be
covered under the warranty.
POSSIBLE CAUSE
Poor power or ground connection
Blown fuse
Wrong flash configuration
SOLUTION
In CC Lightbars, a green light on the central
control board should flash when power is
first applied to the bar and during flash pat-
tern selection.
Check wiring, replace fuse
Cycle through flash patterns according to
the supplied wire key and wiring instruc-
tions section of this installation guide.
Learn more about emergency and warning lighting on our website.
Advertisement
Table of Contents
