Daikin McQuay AGZ-D Operating And Maintenance Manual page 63

Table 17, Alarm Content
State
Illuminated
Flashing
Off
Table 18, LO/RE LED and RUN LED Indictors
LED
When the operator
is selected for Run
command and
frequency
reference control
(LOCAL)
During run
Examples
OMM 1087
Content
When the drive detects an alarm or error
When an alarm occurs
When an oPE is detected
When a fault or error occurs during Auto-Tuning
Normal operation (no fault or alarm)
Lit Flashing Slowly
--
 During
deceleration to
stop
 When a Run
command is input
and frequency
reference is 0 Hz
AGZ 025D through 190D
Flashing Quickly
--
 While the drive was set to
LOCAL, a Run command
was entered to the input
terminals then the drive was
switched to REMOTE.
 A Run command was
entered via the input
terminals while the drive was
not in the Drive Mode.
 During deceleration when a
Fast Stop command was
entered.
 The drive output is shut of by
the Safe Disable function.
 The STOP key was pressed
while drive was running in
REMOTE.
 The drive was powered up
with b1-17 = 0 (default) while
the Run command was
active.
Display
Off
When a device other
than the operator is
selected for Run
command and
frequency reference
control (REMOTE)
During stop
63