Table of Contents
Advertisement
2
1
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part to
the door. Refer to the image.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
You cannot activate or operate
the hob.
You cannot activate or operate
the hob.
A
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Touch only one sensor field.
Clean the control panel.
Remedy
29
Advertisement
Table of Contents
