Table of Contents
Advertisement
CLEANING THE CAVITY EMBOSSMENT
The cleaning procedure removes limestone residue
from the cavity embossment after cooking with
steam.
For the function: Plus Steam we
recommend to do the cleaning
procedure at least every 5 - 10
cooking cycles.
1. Put 250 ml of white vinegar into the cavity
embossment at the bottom of the oven.
Use maximum 6% vinegar without any
additives.
2. Let the vinegar dissolve the residual limestone
at the ambient temperature for 30 minutes.
3. Clean the cavity with warm water and a soft
cloth.
REMOVING THE SHELF SUPPORTS
To clean the oven, remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the shelf supports in the opposite sequence.
CAUTION! Make sure that the longer
fixing wire is in the front. The ends of
the two wires must point to the rear.
Incorrect installation can cause
damage to the enamel.
28
2
REMOVING AND CLEANING THE DOOR
GLASSES - TOP OVEN
The door glass in your product can be
different in type and shape from the
examples you see in the image. The
number of glasses can also be
different.
1. Open the door.
2. Hold the door trim on the top edge of the door
at the two sides and push inwards to release
the clip seal.
1
3. Pull the door trim to the front to remove it.
4. Remove the glass panels.
To install the panels, do the same steps in reverse.
REMOVING AND CLEANING THE DOOR
GLASSES - MAIN OVEN
The door glass in your product can be
different in type and shape from the
example you see in the image. The
number of glasses can also be
different.
1. Push the door trim at one side to remove it.
1
2
Advertisement
Table of Contents
