Program Selection and Operating Your Machine
•
Check if the upper and lower impellers
rotate freely.
•
Put sufficient amount of detergent in the
detergent dispenser and close its lid.
•
Press On/Off button.
•
Check if the salt and rinse aid warning
indicators light and add salt and/or
rinse aid if needed.
•
Determine your washing program with
the aid of the Program Data and Table
of Average Consumption Values.
•
You can select the determined washing
program by pressing program selection
button.
•
You can see the program time in the
Remaining Time Indicator.
•
If necessary, you can change your
washing program as you prefer by
means of the Add Function Buttons.
•
Start the program by pressing the Start
/ Pause / Cancel button.
C
Pay attention not to open the
door of the machine when it is
running. Stop the machine by
pressing Start / Pause / Cancel
button if you have to open the
door. Then, open the door of
your machine. There may be a
rush of vapor when you open
the door of your machine; be
careful. Close the door and
press Start/Pause/Cancel button
again. Program will resume
running.
•
End of Program indicator will light up.
•
Turn off your machine by pressing On /
Off button.
•
Close the tap.
•
Unplug the mains plug from the wall
socket.
•
Leave your dishes in the machine for
about 15 minutes after they are washed
in order to have them cooled down.
Your dishes will dry in a shorter time
if you leave the door of your machine
ajar during this period. This will
increase the drying effectiveness
of your machine.
27 / 36 EN