Detergent; Adding Detergent - Gram OM 62-37 T Instruction Manual

Preparation
C
Salt reservoir will fill with water
when you start the product.
Therefore, add the softening salt
before starting the machine.
C
Before initial use, fill the water
softening system with 1 litre of
water (C).
3. Fill the salt reservoir with salt by using
salt funnel (D). To speed up dissolution
rate of salt in water, stir it with a spoon.
C
You can put about 2 kg of
dishwasher salt into the salt
reservoir.
4. Replace the lid and tighten it securely
when the reservoir is full.
5. If you will not start a washing
programme immediately after adding
the salt, run the machine empty in the
shortest programme to dissolve and
wash away the scattered salt in the
machine.
C
Since different salt brands in the
market have different particle
sizes and since the water
hardness may vary, dissolution
of the salt in water may take
a couple of hours. Therefore,
Salt Indicator remains on for a
while after adding salt into the
machine.
Loose salt grains can cause rust
marks in your machine if not
rinsed away. Only fill salt just
before a programme is run.

Detergent

You can use powder, liquid/gel and tablet
detergents in the machine.
C
Only use the detergents
produced particularly for
use with dishwashers. Never
use washing up liquids. We
recommend you not to use
detergents that contain chlorine
and phosphate as they are
harmful for the environment.

Adding detergent

C
Refer to the "Programme Table"
to determine the correct amount
of detergent for the selected
programme.
C
In order to have good washing
and drying results, always follow
the instructions on the detergent
packaging. If you have further
questions, we recommend to
contact with the producer of the
detergent.
13 / 36 EN