Table of Contents
Advertisement
Preparation
up to a specific degree of water hardness.
Above this limit regeneration salt and rinse
aid must be added. Refer to the instructions
on the packaging of the combined detergent
whether it is suitable for the hardness level of
the water supply.
C
While using combined tablet
detergents contact with the
detergent producers if the dishes
are wet and/or if you notice
limescale spots particularly
on glasses after the washing
programme is over.
C
The best washing performance in
dishwashers is obtained by using
detergent, rinse aid and water
softening salt individually.
When you switch to powder, liquid/gel or
tablet detergent from a combined tablet
detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the highest
level and perform an empty run.
3. After the empty washing cycle, review
the user manual and readjust the water
hardness level so as to suit the water
supply.
4. Make the appropriate rinse aid settings.
C
Depending on the model, salt
indicator and/or rinse aid
indicator must be enabled again
if they were disabled before.
Rinse aid
C
The rinse aid used in dishwashers
is a special combination used
to increase drying efficiency
and prevent water or limescale
stains on the washed items. For
this reason, care must be paid
to have rinse aid in the rinse
aid reservoir and to use rinse
aids produced specially for
dishwashers only.
1. Open the lid of the rinse aid reservoir by
pressing its latch (B).
2. Fill the reservoir until "MAX" level.
3. Turn the rinse aid amount adjuster
manually to a position between 1 and
6 (4). If there are stains on tableware
items after washing, level must be
increased and if there is a blue trace
after wiping them by hand, it must be
15 / 36 EN
Advertisement
Table of Contents
