Table of Contents
Advertisement
Program Selection and Operating Your Machine
Adding Functions to the
Program
With the help of the add function buttons,
you can run the selected program together
with the Half Load
functions.
To add a function to the program:
1.
Select the program by pressing
program selection button.
2.
Press the button of the function that you
want to enable and check to see a
indicator for the relevant function on the
display.
3.
You can start the program by pressing
the Start / Pause / Cancel button.
Program Steps Follow-up
You can follow up the step while current
program is running from the Program Steps
follow up indicator.
a Washing Step Indicator
b Drying Step Indicator
c End of Program Indicator
The display shows the steps for washing
and drying, respectively, while the selected
program is running. Only the End of Program
indicator lights up when the program is over.
Remaining Time Indicator displays "0:00".
Canceling a Program
Press Start / Pause / Cancel button for
three seconds to cancel a program that is
already running. Release the button when
and Delayed Start
symbol start flashing in the display. For
a couple of minutes the machine will fulfill
the necessary operations required for
cancellation. Remaining time indicator (11)
displays "0:00". You may select and operate
a new program following the program
cancellation process. There might be
residues of detergent or rinse aid left in the
machine and/or on the pieces being washed
depending on the step the previous program
was in at the time of such cancellation.
Programming the Delayed
Start
You can delay the start of the selected
program until 9 hours. Delayed start can not
be set after the program starts. The selected
program must not be started in order to be
able to set the delay time.
Delayed start indicator
start flashing when the delayed start button
is pressed. You can set the desired time by
pressing the delayed start button. Press the
Start / Pause / Cancel button after setting
the time. The delayed start indicator
glass and play icon will remain lit on the
display during the delayed start countdown
and the delay time indicator will display
the remaining time. Program will start
automatically when the countdown is over.
You can use the delayed start function if you
are utilizing the economic electricity tariff.
If you want to change the program or
functions while the delayed start function
is enabled, then pause the machine by
pressing the Start / Pause / Cancel button.
You will see that the countdown stops. The
sand glass will
sand
25 / 36 EN
Advertisement
Table of Contents
