Connectors; Front Panel Connectors - Shuttle MB11 User Manual

Connectors

Connectors
3.
3
Front Panel Connectors (J18)
PW-LED Connector - PWR-LED
Attach 3-pin Power-LED connector cable from the housing front panel to PWR-LED
header on the mainboard. The power LED stays lights while the system is running.
Speaker Connector - SPK
Attach the PC speaker cable from the case to the 4-pin speaker connector (SPK).
Hardware Reset Connector - RST
Attach the 2-pin hardware reset switch cable to RST header. Closing the reset switch causes the
system to restart.
HDD LED Connector - IDE LED
Attach the connector cable from the IDE device LED to the 2-pin IDE LED header. The
HDD LED lights up whenever an IDE device is active.
Green LED Connector - GRN LED
Attach a 2-pin Green LED cable to it. The Green LED lights when the system get into
power saving mode. The Green LED off when the system resume back to normal mode.
EPMI Connector - SMI
Hardware System Management Interface connector may attach a 2-pin momentary switch
to it. When push it will force system get into power saving mode, and the system will
resume when switch is pushed again.
ATX Power On/Off Switch Connector - PWR-SW
Attach a 2-pin momentary type switch to this connector for turning on or off your ATX
power supply.
- 14 -
Figure 3-7