Table of Contents
Advertisement
3
3
H
ARDWARE
The Installation PPGA Celeron Processor
The Installation PPGA Celeron Processor
3.
1
MB11/MZ11 mainboard provides a 370-pin ZIF Socket370 for Intel PPGA Celeron CPU.
The CPU that came with the mainboard should have a fan attached to it to prevent over-
heating. If this is not the case then purchase a fan before you turn on your system.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
Socket370 and open it by first pulling the lever sideways away from the socket then
upwards to a 90-degree right angle. Insert the CPU with the correct orientation as
shown.(Figure 3-1) Use the notched corner of the CPU as your guide. The notched corner
should point towards the end of the lever. Notice that there are two blank area where one
hole is missing from that corner of the square array of pin holes. Because the CPU has a
corner pin for two of the four corner, the CPU will only fit in the one orientation, hold
down on the CPU and close the socket's lever.
Figure 3-1
Then you should have a CPU fan that will
cover the face of the CPU. Apply thermal
jelly to the CPU metallic top and then
install the fan onto the CPU. (Figure 3-2 )
I
NSTALLATION
Figure 3-2
- 10 -
Advertisement
Table of Contents
