Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Replacing the display panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1
Slide the display cable into the connector on the display panel and close the
latch to secure the cable.
2
Adhere the tape that secures the display cable to the display panel.
3
Turn the display panel over and gently place it on the display back-cover and
antenna assembly.
4
Align the screw holes on the display panel with the screw holes on the display
back-cover and antenna assembly.
5
Replace the four screws (M2x3) that secure the display panel to the display
back-cover and antenna assembly.
Post-requisites
1
Replace the
logo
2
Replace the
display
3
Replace the
display
4
Follow the procedure from step 2 to step 15 in
5
Replace the
computer
6
Replace the
rear-I/O
7
Replace the
memory
8
Replace the
solid-state
9
Replace the
wireless
10 Follow the procedure from step 4 to step 7 in
11 Replace the
base
computer. After working inside your
board.
bezel.
assembly.
base.
cover.
modules.
drive.
card.
cover.
After working inside your
"Replacing the system
"Replacing the hard
computer.
board".
drive".
107
Advertisement
Table of Contents
