4.2.6 Faceup tray
(1) Draw out the Duplex unit ① .
(2) Open the faceup tray ② in the direction of arrow, and unlock the left and right
pins while bending. Remove the faceup tray ② .
4.2.7 Rear cover
①
Claw C
②
(1) Open the faceup tray.
(2) Remove the two screws (silver, No:42920406) ① .
(3) As shown in fig 2, insert the flat-blade screwdriver into the hole A to disengage
the claw A (2 place).
(4) Disengage the claw B (2 places) and pull the upper side of the rear cover ② in
the direction of A.
(5) As shown in fig 3, push the lower side of the rear cover ② in the direction of B,
and disengage the claw C (3 places) to remove the rear cover ② .
①
Figure (1)
A
②
Claw A
Claw B
B
Figure (3)
4. Component replacement
②
①
A
Hole A
Claw B
Claw A
Claw C
Figure (2)
Hole A
76 /