Toro 29516 Operator's Manual page 42

3. Shut off the engine, engage the parking brake,
wait for all moving parts to stop, and remove
the key.
4. Allow the engine to cool.
5. Carefully clean the area around the front of the
auxiliary pump and fill cap; also clean around the
filter. It is important that no dirt or contamination
enter hydraulic system.
6. Loosen the suction hose at the pump fitting,
clean around the pump fitting, and allow oil to
drain (Figure 51).
1. Auxiliary pump
7. Install the suction hose and torque to 50 N-m
(37 ft-lb).
Changing the Filter
Service Interval: After the first 100 hours
Every 250 hours thereafter
1. Unscrew the filter to remove it and allow oil to
drain (Figure 52).
Figure 51
2. Suction hose
1. Filter (auxiliary-hydraulic system)
2. Apply a thin coat of the specified hydraulic fluid
to the rubber seal of the new filter; refer to
Auxiliary Hydraulic Fluid Specification (page
g268753
3. Turn the filter clockwise until rubber seal
contacts the filter adapter, then tighten the filter
an additional 2/3 to 3/4 turn
Adding Auxiliary Hydraulic Fluid
1. Remove the cap and check the hydraulic-fluid
level in the reservoir.
2. Add the specified hydraulic fluid until the level
reaches the FULL COLD line located on the
reservoir tank; refer to
Fluid Specification (page 41)
Auxiliary Hydraulic Fluid Level (page
Note:
If the fluid is at ambient-air temperature,
about 24°C (75° F), fill only to the FULL COLD
level.
3. Install the hydraulic reservoir cap and tighten it
until snug.
Note:
Do not overtighten the reservoir cap.
4. Start the engine and raise and lower the tines.
Lower the tines to the ground and refill the
reservoir to the FULL COLD line.
5. Check the fluid level again; repeat steps
through 5
42
Figure 52
(Figure
Auxiliary Hydraulic
and
until the level does not decrease.
g268752
41).
52).
Checking the
41).
2