Table of Contents
Advertisement
Lubricating the Grease
Fittings
Note:
See the chart below for service intervals.
1.
Shut off the engine, wait for all moving parts to
stop, and remove the key. Engage the parking
brake.
2.
Lubricate the fittings with NLGI grade No. 2
multi-purpose grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Initial
Locations
Pumps
1. Front Wheel
1
Caster Hubs
2. Tine Shaft
1
Bearings
3. Belt Idler
1
Pivot
Figure 30
1. Front wheel caster hubs
2. Tine shaft bearings
Number of
Service
Places
Interval
2
Yearly
4
25 hours
1
Yearly
g230394
3. Belt idler pivot
Engine Maintenance
Servicing the Air Cleaner
Service Interval: Every 50 hours—Clean the foam
pre-cleaner (more frequently in
dusty conditions).
Every 200 hours—Replace the foam
pre-cleaner.
Every 300 hours—Replace the paper air filter
(more frequently in dusty conditions).
Important:
Do not operate the engine without the
air filter assembly; extreme engine damage may
occur.
1.
Release the latches on the cover for the air
cleaner.
2.
Remove the cover and clean it thoroughly
(Figure
31).
Note:
Be careful to prevent dirt and debris from
falling into the base.
1. Air-filter base
2. Paper air filter
3. Foam pre-cleaner
3.
Remove the foam pre-cleaner, wash it with a
mild detergent and water, and then blot it dry
(Figure
31).
4.
Remove and inspect the paper air filter
31); discard it if it is excessively dirty.
Important:
Do not try to clean a paper filter.
31
Figure 31
4. Cover
5. Latch on the air-cleaner
cover (2)
g023795
(Figure
Advertisement
Table of Contents
