Table of Contents
Advertisement
Shutting Off the Engine
1.
Move the motion-control levers back to the
neutral position and bring the machine to a full
stop.
2.
Lift your foot off of the tine ground engagement
foot switch control to raise the tines.
3.
Activate the tine engagement foot switch lockout.
4.
Place the throttle midway between the S
and F
positions.
AST
5.
Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the O
position to shut off the engine.
6.
Engage the parking brake.
7.
Remove the key to prevent children or other
unauthorized persons from starting the engine.
8.
Close the fuel-shutoff valve when you will not
use the machine for a few days, when you are
transporting the machine, or when the machine
is parked inside a building.
Driving the Machine
CAUTION
Machine can spin very rapidly by positioning
one lever too much ahead of the other.
Operator may lose control of the machine,
which may cause damage to the machine or
injury.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
Important:
To begin movement (forward or
backward), the brake lever must be disengaged
(pushed forward) before the motion-control levers
can be moved.
LOW
FF
1. Left motion-control lever
2. Right motion-control lever
3. Front reference bar
4. Front of machine
Driving Forward
1.
Ensure that the motion-control levers are in the
neutral position.
2.
Release the parking brake.
3.
To move forward in a straight line, move both
levers forward with equal pressure.
To turn left or right, pull the motion-control lever
back toward neutral in the desired turn direction.
The tines can be in the down position when
making gradual turns.
To make zero-degree turns, lift your foot off the
tine engagement foot switch control to raise the
tines. The head will raise in 1 second.
23
Figure 23
5. Forward
6. Neutral
7. Reverse
8. Rear reference bar
Figure 24
g223330
g016672
Advertisement
Table of Contents
