Page 2
TSC Proofer Oven Firmware Load Instructions Firmware load should take under 5 minutes to complete. 1) Cycle the main power switch on the right side of the oven to OFF. CIRCUIT BREAKER (POWER SWITCH) 2) Remove Dust Cap and insert USB drive into USB port on the left side of the oven.
Page 3
6) Remove the USB drive and replace Dust Cap. 7) Cycle Main Power Switch on the right side of the oven to “OFF” then back to “ON”. Allow “DUKE” screen to display. Confirm the new version of Firmware is loaded and is displayed in the lower right hand corner of the screen.
Page 4
2305 N. Broadway St. Louis, MO 63102 Phone: 314-231-1130 Toll Free: 800-735-3853 Fax: 314-231-5074 www.dukemfg.com Duke EMEA - Europe, Middle East, Africa, Russia Duke Manufacturing CR, s.r.o. Zdebradska 92 Jazlovice, Ricany Building number DC 4 on the ProLogis Park Prague D1 West...
Need help?
Do you have a question about the TSC and is the answer not in the manual?
Questions and answers