En] Bluetooth Connection Issues With Victronconnect - Victron energy Orion-Tr Smart Manual

7.3.

[en] Bluetooth connection issues with VictronConnect

[en] In the normal state, the blue Bluetooth LED should blink every 0.8 seconds when there is a connection between the
VictronConnect app and the Orion-Tr Smart DC-DC Charger. See the
different LED codes.
[en] If not, check the following:
[en] Blue LED [en] LED
status duration
[en] Off [en] -
[en] Every 0.8
[en] Blinking
seconds
[en] For all other connection problems, please consult the
issues.
Seite 19
Orion-Tr Smart DC-DC Ladegerät Nicht Isoliert
LEDs [14]
[en] No input voltage: The Bluetooth controller is powered by the battery
connected to the input terminals. Restore the battery supply.
[en] Bluetooth has been disabled in the VictronConnect setting: This cannot be
undone. We recommend leaving Bluetooth on at all times.
[en] The Bluetooth option "Enabled for 30 seconds" was selected on the
product info page. This means Bluetooth is active for 30 seconds after
powering up the Orion. After 30 seconds, Bluetooth turns off until the next
power-up. Disconnect and reconnect the battery input cable. Then connect to
the Orion via VictronConnect within 30 seconds and set the Bluetooth option to
'Enabled'.
[en] If none of the above applies, the unit may be faulty; submit a warranty
claim.
[en] There is already a Bluetooth connection active. Only one phone or tablet
can connect via Bluetooth at a time; is perhaps another phone or tablet already
connected? A clear indicator of this is that the Orion is visible in
VictronConnect but greyed out.
VictronConnect manual
section and learn more about the meaning of the
[en] Action to take
for troubleshooting Bluetooth connection
Fehlerbehebung