7.3.1 Handle
These general advices are completed with specific repair tips in this chapter.
1. Unscrew one of the screws on the handle.
2. Then unscrew both rear screws completely out of the unit.
3. Now remove the lever completely by pulling both lever arms out of the seats in the
rear housing.
(When re-assembling the handle, dip the ends of the screws into Loctite 243 to en-
sure good fixation. Failure to do so might result in machine not being able to brew
coffees.)
R E P A I R S
Service manual ZN100 V 6.0
43