Removing The Rear Panel - Nespresso ZENIUS ZN 100 PRO Service Manual

7.3.5 Removing the rear panel

This disassembly step builds on the preceding step and is not feasible without it.
18. With your fingers or an appropriate tool disconnect the water sensor PC board's
connection cable connector from the mainboard.
19. Set the unit on its side and unscrew the 3 screws from the rear of the housing
bottom.
20. Stand the unit upright again.
21. Raise the back slightly and remove it from the rest of the housing.
22. Now carefully remove the back and the connection cable from the housing.
R E P A I R S
Service manual ZN100 V 6.0
47