Husqvarna Blastrac EBE 500 Operator's Manual page 15

3. Attach the dust collector hose safely to the dust
collector connection. Connect the dust collector hose
with hose clamps and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the fan unit
1. Start the product. Refer to
page 15 .
2. After some seconds, stop the product. Refer to
stop the product on page 18 .
3. Make sure that the fan unit has the correct direction
of rotation. The correct direction is shown with an
arrow on the fan unit cover.
4. If it is necessary, change the phase sequence of the
power supply to change the direction of rotation of
the fan unit.
To select the correct speed
It is important to operate the product with the correct
speed for best result. If the surface has different quality,
adjust the speed for an equal result. Examine the result
and adjust the speed if it is necessary.
2107 - 001 - 27.07.2023
To start the product on
To
• Turn the speed control clockwise to increase the
speed.
• Turn the speed control counterclockwise to decrease
the speed.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 15 .
2. Attach the dust collector hose to the product. Refer
To connect a dust collector on page 14 .
to
3. Start the dust collector. Refer to the operator's
manual of the dust collector.
4. Put the cord of the operator presence control around
your left wrist.
5. Turn the emergency stop button clockwise to
disengage the emergency stop button.
6. Set the ON/OFF switch to the ON position (A).
B
C
7. Start the drive motors (B) and the fan unit (C).
8. Do a check of the direction of rotation of the fan unit.
To do a check of the direction of rotation of
Refer to
the fan unit on page 15 .
9. Start the the blast motor (D).
To operate the product
WARNING:
during operation. Abrasive material comes
D
A
Do not lift or tilt the product
To
15