Husqvarna Blastrac EBE 500 Operator's Manual page 13

2. Operate the control lever for the abrasive material
(B) to open the valve and start the flow of the
abrasive material.
Abrasive material seal
The abrasive material seal has 2 side seals, 1 front
rubber seal and 2 brush list seals. The abrasive material
seal makes sure that the abrasive material stays in the
product during operation.
To set the correct height of the brush list seals
The brush list seals wear when you operate the product.
It is necessary adjust the height of the brush list seals at
regular intervals.
1. Loosen the 4 screws.
2. Adjust the height until the brush list seals are 1 mm/
0.04 in above the surface.
2107 - 001 - 27.07.2023
3. Tighten the 4 screws.
To install the side seals
The side seals fall out from the side seal box when you
lift the product from the surface. Install the side seals
before you operate the product.
1. Put a ramp behind 1 of the rear wheels. Operate the
product rearward up the ramp.
2. Stop the product when the distance (A) is 75 mm.
3. Put the side seal (B) in the side seal box. Make sure
that the rounded part of the side seal points to the
front of the product.
B
4. Use an applicable tool to hold the side seal in
position while a second person operates the product
down the ramp.
WARNING:
operate the product down the ramp.
There is a risk of pinching.
5. Do the procedure on the other side of the product.
A
Be careful when you
13