Related Manuals for HJC RPHA 71
Summary of Contents for HJC RPHA 71
- Page 2 18. Eyeport Gasket 5. Rubber edge trim 12. Shield locking system 19. Shield Ratchet 6. Bluetooth Cover 13. Front chin vent 20. Top Front Vent 7. Sun shield lever 14. Breath deflector ※ Please visit www.hjchelmets.com for more information about HJC helmets.
- Page 3 Visor(Shield) Removal 1. Press the visor(shield) locker, then lift the visor(shield) tab up. 2. Open visor(shield) to the maximum open position. 3. Pull the handle-locker to the open position, then pull out the visor(shield) from ratchet mechanism. OPEN OPEN OPEN Visor(shield) tab Visor(shield) tab Visor(shield) tab...
- Page 4 Crown Pad Installation Cheek Pad Installation 1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring 1. Align and fully slide the cheek pad plastic plate between shell and EPS. that the center and side holes are properly aligned. Press the crown pad plastic sleeve (center portion) 2.
-
Page 5: Sun Shield Installation
Warning! Sun shield Removal ■ Try not to operate the sun shield while riding as this may impair your vision and may lead to an accident. 1. Place the stopper in Stage 3. ■ 2. Push the sun shield lever in the direction of the arrow to lower the sun shield as much as possible. DO NOT pull on the sun shield when it is already down. - Page 6 Breath Deflector Removal Lower Vent Operation 1. To remove the breath deflector, pull in the direction of the arrow. ＊Lower Vents open in two ways, and the amount of intake and exhaust can be adjusted. 1. Press the bottom of the lower vent door once to open the first stage. 2.
-
Page 7: Emergency Kit
Emergency Kit HJC Intercom Placement Guide Mounting the Intercom In an emergency, you may remove the cheek pads as Unscrew and remove the base cover at the back of the helmet to begin mounting process indicated in the illustration. Pull the red line pocket with of the intercom.