Related Manuals for HJC RPHA 91
Summary of Contents for HJC RPHA 91
- Page 2 12. Chin bar lever 19. Visor(Shield) ratchet 6. Sun shield lever 13. Front chin vent 20. Top vent 7. Chin strap 14. HJ-37 Visor(Shield) 21. Rear venturi exhausts 22. Rear exhaust venturi spoiler ※ Please visit www.hjchelmets.com for more information about HJC helmets.
- Page 3 Warning! Visor (Shield) Removal Always check to make sure helmet pads are installed before using the helmet. A helmet with missing or improperly installed pads may increase your risk of serious injury or death in an accident. 1. Open visor(shield) to the maximum open position. 2.
- Page 4 Cheek Pad Removal Neck Roll Removal 1. Remove Snap between the Cheek pad and neck roll. 1. Remove Snap between the Cheek pad and neck roll. 2. Gently pry the cheek pad away from the interior, releasing the snaps. 2. Pull out the Neck roll to remove. 3.
-
Page 5: Sun Shield Installation
Warning! Sun shield Removal ■ Try not to operate the sun shield while riding as this may impair your vision and may lead to an accident. 1. Place the stopper in stage 3. ■ DO NOT pull on the sun shield when it is already down. The sun shield may be ejected and this will increase the risk of serious injury or death in the event of an accident. - Page 6 Chin Curtain Removal Wearing Mode Operation ※Helmet can be put on and removed easily when both chin bar and visor(shield) are in the open position. 1. Grasp the chin curtain fabric at the bottom corners and gently pull the sleeve down and away 1.
- Page 7 HJC Intercom Placement Guide 2. The chin bar is in the full open position when you hear “click” sound. Mounting the Intercom Unscrew and remove the base cover at the back of the helmet to begin mounting process of the intercom. Please refer to the manual of the current intercom you are using for directions on mounting and unmounting the intercom unit.