Download Print this page

HJC RPHA 71 Owner's Manual page 3

Visor(Shield) Removal

1. Press the visor(shield) locker, then lift the visor(shield) tab up.

2. Open visor(shield) to the maximum open position.

3. Pull the handle-locker to the open position, then pull out the visor(shield) from ratchet mechanism.

Visor(shield) tab

Visor(shield) locker

Handle-locker

OPEN

Visor(Shield) Installation

1. Ensure that the handle-locker is in the open position.

2. Align and insert the top of the shield guide into the plate-gear guide.

3. With the guides properly aligned, press the lower section of the shield into the plate-gear mechanism.

The locking tab should pop into position, locking the shield into place.

Warning!

Always check to make sure helmet pads are installed before using the helmet. A helmet with

missing or improperly installed pads may increase your risk of serious injury or death in an accident.

Cheek Pad Removal

There are 3 snaps holding the cheek pad in place.

1. Gently pry the cheek pad away from the interior, releasing the snaps.

2. Grasp the cheek pad near its center and gently pull it free from the chin strap.

OPEN