Advertisement
Cheek Pad Installation
1. Align and fully slide the cheek pad plastic plate between shell and EPS.
2. Clip the cheek pad's 3 small male snaps to the 3 female snaps fixed on the shell interior.
1
Position of tap holder
Position of tap holder
Position of tap holder
B
B
1a
1b
A
A
A A
※Slide tab 'A' from the cheek pad into the holder 'B' . (Repeat same on opposite side)
Crown Pad Removal
1. Grasp the crown pad fabric as close as possible to its plastic base and pull/pry away from the helmet.
Notice how the crown pad plastic section aligns with the shell plastic sleeve. This will help orient you
with the reinstallation.
2. Repeat same at rear.
1
5
2
B
B
A
A A
2
Crown Pad Installation
1. Install the front section first by aligning the plastic shell base and the crown pad plastic sleeve, ensuring
that the center and side holes are properly aligned. Press the crown pad plastic sleeve (center portion)
into the center of the channel which is built into the plasticshell base, working your way outward to each
side.
2. Align and snap the two rear snaps into place.
1
Chin Strap Cover Removal
1
Chin Strap Cover Installation
1. Insert the chin strap into the chin strap cover and push the chin strap all the way in.
1a
1. Grasp the end of the chin strap cover and pull/pry
away from the helmet.
1b
2
6
Advertisement
