Page 1
INadb025_FR A71-035V00 Yoga Trampoline IMPORTANT : À LIRE ATTENTIVEMENT ET À CONSERVER POUR TOUTE RÉFÉRENCE ULTÉRIEURE MANUEL...
Page 2
Tables des Matières Avertissement : Ce produit est déconseillé aux enfants de moins de 6 ans. Pour prévenir les accidents, la surveillance d'un adulte est toujours requise. Veuillez lire attentivement toutes les instructions avant l'installation - conservez ce manuel pour pouvoir vous y référer ultérieurement. Considérations importantes Schéma d'analyse du produit Liste des pièces...
Page 3
Consignes Importantes 1. Ce produit est recommandé pour les personnes âgées de plus de 7 ans. La charge maximale est de 100 kg. 2. Les pieds du lit du trampoline sont bien fixés lors du montage. Assurez-vous que les pieds du lit ne soient pas déformés par la force pendant le processus d'assem- blage.
Page 4
Consignes Importantes 13. Lisez le manuel et comprenez toutes les consignes avant l'utilisation - con- servez-le pour pouvoir le consulter ultérieurement. 14. Assurez-vous que le trampoline est assemblé correctement, en suivant toutes les instructions de ce manuel avant toute utilisation. 15.
Page 5
Schéma d'analyse du produit Accoudoir transversal Support Accoudoir droit Trampoline Vis pentagonale Liaison du support Vis triangulaire Goupille de sécurité Tube de pied Ventouse en caoutchouc...
Page 6
Liste des pièces 1.Trampoline x1 2.Tube de pied x6 3.Support Accoudoir x2 4.Accoudoir transversal x1 5.Liaison du support x2 Vis pentagonale x4 Vis triangulaire x4 Ventouse du pied silencieux x6 Goupille de sécurité x2...
Page 7
Étapes de l'installation Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Étape 1: Le trampoline dans sa position pliée sur le sol (Fig. 1), tirez sur les côtés gauche et droit, de sorte que le trampoline forme un demi-cercle. Assurez-vous que la tige de la pince de pliage est proche du sol (Fig.
Page 8
Étapes de l'installation Fig. 6 Fig. 7 Fig. 8 Étape 5: Retirez le bouchon du pied silencieux ou la ventouse, positionnez la tige de con- nexion du support respectivement sur les deux pieds respectivement (Fig. 6), puis verrouillez avec les vis triangulaires. Lorsque vous vissez le tube du pied, retenez-le et non la tige de support.
Page 9
Étapes de l'installation Fig. 9 Fig. 10 Étape 8: Faites glisser le support du capteur sur le pied du lit. Lorsque le capteur touche le trampoline (Fig 9), il doit être en contact horizontal avec le tapis de saut. Serrez les vis triangulaires du support du capteur (Figure 9).
Page 11
Catalog Warning: This product is not suitable for children under 6 years old. To prevent accidents, please use it under the supervision of adults at all times! Please read the manual carefully before installing the product and keep the manual properly.
Page 12
Important notes 1. This product is recommended for ages over 7 years. The maximum load is 100kg. 2. The bed legs of the trampoline are firmly installed during assembly. Ensure the bed legs are not deformed due to force during the assembly process. 3.
Page 13
Important notes 13. Read and understand all information before use – keep for future reference. 14. Before use, ensure the trampoline is assembled correctly, following all instructions in this manual. 15. Only to be used by one person at a time. 16.
Page 14
Product analysis diagram Armrest corss Right armrest bracket Trampoline Pentagonal screw Bracket link Triangle screw Safety bolt Leg tube Rubber sucker -14-...
Page 15
Part list 1.Trampoline x1 2.Leg tube x6 3.Armrest bracket x2 4.Armrest corss x1 5.Bracket link x2 Suction cup x6 Pentagonal screw x4 Triangle screw x4 Safety bolt x2 -15-...
Page 16
Installation steps Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Step 1: Place the trampoline on the floor in its folded position (Fig. 1), pull the left and right sides, so the trampoline is in a semi circle. Ensure the folding clamp stick is close to the ground (Fig.
Page 17
Installation steps Fig. 6 Fig. 7 Fig. 8 Step 5: Pull out the silent foot plug or suction cup, put the support connecting rod on the two feet respectively (Fig. 6), then lock with triangle screws. When screwing the foot tube, hold it and not the support rod. Step 6: After connecting the handrail bracket with the cross bar, tighten with triangle screws (Fig.
Page 18
Installation steps Fig. 9 Fig. 10 Step 8: Slide the sensor bracket over the foot of the bed. When the sensor touches the trampoline (Figure 9), it should be in horizontal contact with the jumping cloth. Tighten the triangular screws on the sensor bracket (Figure 9). Insert the computer into the sensor holder.
Need help?
Do you have a question about the A71-035V00 and is the answer not in the manual?
Questions and answers