Table of Contents
Advertisement
Every 20 hours of operation
16.1.1) Check screws
Check and re-tighten all screws where necessary.
16.1.2) Top up oil
With the drill placed on a flat surface, check the oil level in the
sump by looking through the appropriate transparent inspection
cover (13). The level must be approximately half way up the
cover; if the level is low top up the oil adding the quantity of oil
required. To access the oil filler cap (07) follow the instructions
on previous page.
Only use the oil grade recommended in § 1.
Never use regenerated or used oil.
The oil must be clean.
16.1.3) Remove metallic residues from the crankcase
When the drill is positioned as shown in Figure unscrew the ap-
propriate cap, with magnetic insert (21) on which any metallic
residue will have collected.
Carefully clean the magnetic insert with a clean rag and screw it
back in the appropriate housing.
Every 50 hours of operation
16.1.4) Lubricate
Lubricate the spindle support housing by means of the appropriate
lubricator (18), the screw (17) of the clamping device with moving arm.
18
07
17
13
21
34
Advertisement
Table of Contents
