Assembly Of Dbg-F2 Clamping Device; Fitting Positioning Templates - Cembre LD-16B-RP Operation And Maintenance Manual

6 mm Allen key
11.6) Assembling positioning templates
Only CEMBRE positioning templates and jigs are to be used with the rail drill.
Choose the correct positioning template for the rail profile to be drilled.
Place the positioning template on to the front plate of the drill, aligning the two reference pins with the holes
in the template.
MPAF.. MPSR and MPAU positioning templates are secured to the front plate by means of two screws M6x16 by
using the 5 mm Allen key supplied in the ACCESSORIES KIT of the drill.
For special positioning templates (e.g MPD... & MPR...) use the two screws M6x25.
Reference pins
23
11.5) Assembly of the DBG-F2 clamping device
The clamping device is fitted to the front plate of the
drill, and secured with the two screws M8x25 (30). The
assembly is illustrated in the Figure.
To disassemble it, using the 6 mm Allen key supplied
in the ACCESSORIES KIT of the drill.
clamping device
If the clamping device must be removed, make
30
sure that, on reassembly, the two locking screws
(30) and washers are firmily fastened.
front plate
front plate
M6x16 screw
5 mm Allen key
M6x16 screw