Table of Contents
Advertisement
15
6) Proceed to drill the hole by initially applying a light pressure on the lever,
gradually pushing it so that the green LED on the indicator display turns on
(Ref. to § 8 for further details); continue this progress, avoiding any changes, so that the green LED stays illumi-
nated for the entire drilling process; only alleviate the pressure on the lever during the exit phase.
During the operating cycle it is possible to check the current revolutions of the
spindle via the OLED display.
To finish drilling, depending on the thickness being drilled, a stroke recovery
may be performed by releasing the lever, as described in point 4 above.
The guide bit will enable the lubrocoolant to be discharged throughout the drilling process.
7) When drilling has been completed, fully retract the spindle, stop the machine by pressing the Motor switch in
0 position "OFF".
Any shut-off of the motor during the drilling process, combined with illumination of an LED on the indicator,
indicates the presence of a fault. In such a case refer to §13.
final position
of the lever
27
5) Start the machine by pressing the Motor switch (15) as described in
the § 5.
If necessary, activate switch (17) for the automatic illumination of
the LED worklights.
17
Green LED
illuminated
0h00m
0h00m
138
RPM
BATTERY
LD-16B
S1K34701 HD4
initial position
of the lever
Advertisement
Table of Contents
