Advertisement
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off remove the Safety Key, and unplug the tool
from its electrical outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy:
DO NOT OpERATE WITH ANy GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
Table Adjustment
1. Raise or lower the Table by loosening the
Table Lock Handle (7) and sliding the Table
Assembly up and down on the Column. Tighten
the Table Lock Handle before drilling.
2. Pivot the Table (6) around the Column by
loosening the Table Lock Handle. The entire Table
Assembly will move as one around the Column.
cAUTION! To prevent injury from
unexpected Table movement, tighten Table
Lock Handle (7) after adjustment.
Setting a Drilling Depth
Located on the left side of the Headstock is the depth
feed adjustment assembly, which allows drilling a
series of holes to the same depth using one setting.
1. Lower the drill (with the power OFF) so that it
contacts the material and hold in that position.
2. Screw down the lower Adjustment Nut (65)
on the Stop Rod (53) until the gap between
the underside of the Nut and the Drill Stop
face equals the depth of the hole required.
3. Screw down the upper Adjustment Nut against
the lower Adjustment Nut to lock setting.
Page 8
Lock
Handle (7)
For technical questions, please call 1-888-866-5797.
3. Tilt the Table by loosening the Bevel Lock
Bolt (8) with a 19 mm socket or wrench (not
included) and tilting to the required angle. The
angle can be read using the Bevel Scale.
4. TO ENSURE THAT THE DRILL IS ENTIRELY
PERPENDICULAR TO THE TABLE,
insert a straight round bar (not included) in
the Chuck, place a square on the Table and bring it
up to the round bar. Adjust the angle as needed.
Note: Alternatively, drilling depth for a one-time
procedure can be determined by lowering the
drill (with the power OFF) until it contacts the
work, noting the position of the Pointer (63) on
the Scale, turning the drill ON, and drilling to the
required depth using the Scale as a guide.
Adjustment
Nuts
Drill
Stop
Bevel
Scale
pointer
(55)
Scale
Stop Rod
(53)
Item 58780
Advertisement
