Table of Contents
Advertisement
EN
Rev.0 23/03/2023
Pag.26
DESCRIPTION OF THE FUNCTIONING AND SYMBOLOGY OF THE DISPLAY
The display of the handheld set is described below (in "Home" mode):
Date
Clock
Room temperature
Working power
Stove status
Key "OK": in the Home screen, long press to turn the appliance on / off or reset the alarms; short press to enter the menu
Key "1": access key to "set room temperature" and regulation (decrease value)
Key "2": access key to "set power" and regulation (increase value)
��
The first press of any key with active display turns on its backlight, not interpreting it as a command.
⚠
PPROCEDURES FOR USE
If the chimney catches fire you must call the fire brigade immediately.
⚠
Checks prior to start-up
You have read and perfectly understood the contents of this instructions manual.
Before lighting the stove, you must ensure that:
•
the combustion chamber is clean;
•
the fire door and ash drawer seals are functioning properly;
•
the electrical plug is connected correctly;
•
all items that could burn (instructions, various adhesive labels) have been removed;
•
the fire pot, if removable, is correctly positioned in its housing.
��
During the first hours of use the paints used for the stove finish may release an unpleasant odour. You might also smell
the typical odour of metal parts subject to high temperatures. Make sure sufficient air circulation is guaranteed in the room.
These unavoidable inconveniences will disappear after the first hours of operation. To reduce your discomfort to a minimum,
keep the stove on for a few hours on low power and in the beginning, do not overload it, avoiding intense heating-cooling
cycles
��
At the initial start-up, the paint finishes drying and hardens. Accordingly, to avoid ruining it, we advise you not to touch the
stove's painted surfaces at this time.
Pellet auger loading
Before starting the stove for the first time, whenever the stove is in alarm "06 - Pellets finished", and in any case whenever the hopper
has emptied completely, the initial auger loading is required.
This phase allows the stove to fill the pellet loading system (the system that carries the pellets from the tank to the fire pot), so that at the
time of ignition, the pellets can be loaded into the fire pot and then the stove can be ignited. If the auger loading operations are not carried
out, the stove could fail to ignite.
⚠
To load the auger, follow the instructions given in the paragraph "Stove status menu".
After loading the auger and before lighting the stove, always remember to empty the fire pot and check that the fire pot is
⚠
clean. Never empty the fire pot inside the hopper.
After each maintenance operation, make sure that the fire pot is positioned correctly in its seat.
Switching the appliance on and off
From the "Home" screen, it is possible to switch the stove on and off by keeping the OK button
⚠
seconds. An acoustic signal will warn you that the appliance has switched on or off.
Do not turn off the stove by disconnecting the electric plug from the wall socket.
Use and maintenance manual Easy 12 C
Key OK, on/off
Key 2, increase value
Key 1, decrease value
pressed on the device for a few
Advertisement
Table of Contents
