Table of Contents
Advertisement
EN
Rev.0 23/03/2023
Pag.34
In the menu VIEW WORKING HOURS you can check the total or partial working hours and also the number of ignitions of the stove.
This menu is used by the After Sales Center to evaluate the total working hours of the stove during the season and consequently to
evaluate the need of cleaning ("service hours").
You can see the working hours of the stove. To scroll the different counters (total or partial hours and number of ignitions) use key 1 and 2.
Menu SET DRAUGH/PELLET
The setting of the PELLET-FLOW mixture allows to adjust the combustion by varying the quantity of pellets loaded in the fire pot and/or the quan-
tity of air. In fact, by its nature, pellets vary in grain size and composition: even bags of pellets of the same brand can have different characteristics.
If combustion is not optimal, vary the flow parameter to adjust the combustion air. If air regulation alone is not sufficient, it may also
⚠
be necessary to modify the pellet parameter.
Combustion regulation is an operation that requires a lot of experience. We recommend that you contact an Authorised
Service Centre to calibrate the stove appropriately.
By accessing the menu, the adjustment of the draft / pellet mixture is displayed. To change the percentage use buttons 1 and 2, to switch
from adjusting the quantity of pellets to adjusting the inlet air flow, press OK.
At the last confirmation with OK, the settings are saved and you automatically return to the icons screen.
Service hours
All our models need in addition to the regular cleaning, also a special cleaning which should be done by the installer (authorized by
the producer).
At the time of the installation it is possible to set a number of working hours appropriate for the model. At the end of these hours on
the display will appear the message "SERVICE HOURS" followed by an acoustic signal. When this message appears please contact
the installer to do the special cleaning of the stove.
If the cleaning is not done the message will appear by each ignition but will not interrupt the functioning of the stove.
Remote control
Infrared handheld device for remote control
• 1 - 2 Set temperature: allows to set the desired value for the room temperature from minimum 6 °C to maximum 40 °C (or from
1
2
5
6
Use and maintenance manual Easy 12 C
44 °F to 104 °F) .
• 3 - 4 Set power: allows to set the working power between a range of minimum 1 to max-
imum 5 .
• 5 ON/OFF: by keeping pressed for 2 second longs it allows the manual switch on and off
of the stove
3
• 6 Without function
4
Advertisement
Table of Contents
