Load Management In Override Mode - LEGRAND Green'up One Installation Manual

6.2.2. Load Management in Override mode

These charging stations are compatible with a variety of home control systems.
The Legrand group has a wide assortment of devices for home control systems. The figure below shows an
example how you can build up load management by devices with Netatmo.
• If the total load reaches the allowed maximum power, the Smart Load Shedder sends a signal to the Con-
nected Dry Contact. The Connected Dry Contact switches off the charging current. When the Connected
Dry Contact gets a signal that the total power consumption has decreased to a set value, it switches on
the charging current.
Power supply
Main fuse
L1 / L2 / L3
Other loads
This installation requires a "with Netatmo" connected
starter pack or a Gateway
Device
Smart Load Shedder
Connected Dry Contact
Please ask our local sales representative detailed information about the required devices for your installation.
38 / 68
Smart
Load
Shedder
module.
e-catalogue Legrand part number
4 121 72
4 121 73
LERAK131B-FRENIT/20230502
Switchboard
Connected
Dry Contact
NC
EVC
EV