Advertisement
Installation
7. Tighten allconnections securely andreplace terminal blockcover.
/
green ground screw
Figure 18: Completed Three Wire Range Cord Connection
8.
Properly secure strain relief. See "Install Strain Relief" on page 12 for detailed
instructions.
Note:
DO NOT plug in range at this time.
Connect Gas Supply
Important note for LP users
Flexible Connector Method
Shut off main gas supply valve before disconnecting the old range and leave it off
until the new hook-up has been completed. Don't forget to relight the pilot on
other gas appliances when you turn the gas back on.
The range can be installed using rigid pipe or a CSA International-certified
flexible
metal appliance connector. If using a flexible connector, always use a new con-
nector.
Apply pipe joint compound or Teflon 1 tape appropriate for use with LP gas and
Natural gas around all male pipe threads to prevent leaks.
The gas connection is located below the back panel of the range. See "Gas Con-
nection Location" on page 16. It is accessible through the drawer access panel or
from the back of the range. To reach access panel, remove drawer.
Figure 19: Gas Connection Location
The range is shipped from the factory for use with natural gas. For use with pro-
pane (LP) gas, your range must first be converted using the LP conversion kit.
If using rigid pipe, skip to "Rigid Pipe Method" on page 19.
English 16
1.Teflon is a registered trademark of DuPont
Advertisement
