Advertisement
Installation
2. Three wirerange cord
Thefourwirerange cordconnection i stherecommended method, butwhere local
codes permit, t hreewireconnections arealsoacceptable.
Note:
InCanada, therange is shipped fromthefactory withtherange cord
already installed. C ontinue t o"Connect GasSupply" o n page16.
Install Strain Relief
For installations other than those in Canada, connect the range cord at the termi-
nal block (See next page for detailed instructions). Access the terminal block by
removing the cover in the lower right hand corner of the range back panel.
Place strain relief in knockout below terminal block. See Figure 11 : Strain Relief
Knockout.
_
WARNING:
The strain relief provided with your range cord must be properly
installed.
Strain reliefs vary. Carefully read and follow the instructions included
with your strain relief.
1.
In the knockout panel below the terminal block, remove the knockout that fits
your strain relief.
2.
Feed range cord through hole and strain relief up to terminal block. Allow for
slack in the cord between the strain relief and terminal block.
3.
Once cord length/slack
has been adjusted, attach strain relief per instructions
included with strain relief.
Figure 11: Strain Relief Knockout
Tip:
The knockout panel below the terminal block can be removed from
the range to install the strain relief: Remove knockout panel from
range, install strain relief in panel and reattach. DO NOT remove
entire range back panel.
English 12
Advertisement
