Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
–
Pull at the top part of the chain with the specified weight
Guideline
Weight, chain wear measurement
–
Measure distance
Info
Chain wear is not always even, so you should repeat this measurement at
different chain positions.
Maximum distance
chain section
»
If distance
–
Change the drivetrain kit.
400987-10
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard
S01249-01
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
S01250-01
B
of 18 chain rollers in the lower chain section.
B
at the longest
B
is greater than the specified measurement:
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on an old, worn rear sprocket or engine
sprocket.
M6
A
.
10... 15 kg (22... 33 lb.)
272 mm (10.71 in)
6 Nm
Loctite
(4.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
60
®
243™
Advertisement
Table of Contents
