GEZE GC 307+ Quick Start Manual page 5

Range
Range
60 cm
Output
Output configuration
Holding time
Aut. reset
Door control
AUTO
OPEN
CLOSED
RESTROOM
LED
Colour of LED
O Blue
No detection
Detection
= Factory setting
To change these settings by remote control, the range must be set to minimum.
0 1 2
small > >
Pulse Toggle
NO NO
If the "output configuration" is set to Pulse (0, 2 or 4), the hold-open time can be adapted
here.
1 s
0.5 s
If the "output configuration" is set to Toggle (1, 3 or 5), it can be determined here when the
system unlocks automatically.
No timer 1 min
5 seconds before the timer expires, the LED flashes and a signal sounds.
AUTO OPEN
With the contact closed at the control INPUT, the output OUT switches when a hand moves in front of
the sensor.
With the contact closed at the control INPUT, the output OUT switches permanently.
With the contact closed at the control INPUT, the output OUT does not switch.
With the contact closed at the control INPUT, the output OUT switches when a hand moves in front of
the sensor optimised for a WC circuit.
To change these settings by remote control, the DIP switches
"Colour of LED" must be set to OFF.
0 1
or
Red
O Red
O Red
Example:
3 4 5 6
> > > >
Pulse
Toggle
NC
NC
2 s
3 s
5 min 15 min
CLOSED RESTROOM
2 3 4
or or or
Green Blue Yellow
Green Blue Yellow Pink Turquoise White
Green Blue Yellow Pink Turquoise White
1
2
7 8 9
> > large
Toggle
Pulse
frequency
frequency
To change
these settings by
5 s
4 s
remote control,
the DIP switches
"Output" must
be set to
OFF.
30 min 60 min
5 6 7
Red Green
No detection
Detection
DIP
1 2
DIP
1 2 3