Table of Contents
Advertisement
···:;
. , . . . -·x-·,
,,,_.-
.. ···
,.r·:.:i,;
.,:
~
.
~=:
; : ; _ -: ;
~~=
j.;;·
;;+=
~-:;~
"' . -.-
...
I
4. Assembly
I
• To prevent electrical shock and damage to the microscope. always turn off the
power switch (flip it to the
"C"
side) and unplug the power cord when
connecting or disconnecting the lamphouse.
• To prevent burns. allow the lamp and lamphouse to cool before replacing it
for at least 30 minutes after using.
• Use the Nikon LHS-HIOOP-2 HALOGEN 12V-100W model for the
lamphouse.
• Use a 12 V-100 W LONGLIFE halogen lamp (OSRAM HLX 64623 or
PHILIPS 7724 ).
• Do not touch the glass surface of the lamp with your bare hands. Doing so
will cause fingerprints. grease. etc .. to burn onto the lamp surface. reducing
the illumination provided by the lamp. If you do get any fingerprints or din
on the lamp. wipe it clean.
• After replacing the lamp. make sure that the lamphouse cover is attached
securely. Never use the lamphouse while its cover is off.
5·1
Check that the power switch is off (the
switch is in the
··o··
position).
5-2 If the lamphouse is already mounted on the
epi-illuminator. loosen the lamphouse clamp
screw with the hexagonal screwdriver and
remove the lamphouse
JJ.
(The clamp
screw is on the right side.)
5-3 Loosen the lamphouse cover clamp screw
with a coin or other tool
llJ
and remove the
cover
'31.
5-4 Securely insert the lamp into the pinholes of
the socket [[] until it does not go in any
farther while pressing down on the lamp
clamp lever
~-
Do not touch the glass portion of the lamp with
your bare hands.
5·5
Return the lamp clamp lever to its original
position.
Be careful so that the lamp is not installed tilting
to one side.
5-6 Securely close the lamphouse cover and
tighten the clamp screw.
5-7 After completely loosening the lamphouse
clamp screw. securely plug the lamphouse
plug into the socket of the lamphouse mount
and then tighten the lamphouse clamp screw.
39
Advertisement
Table of Contents
