Tour Notes; Master Dimmer; Red, Green, Blue, And White Color Selection; Color Macros - Chauvet COLORado 1 tour User Manual

Colorado 1 tour
Hide thumbs Also See for COLORado 1 tour:
Table of Contents

Advertisement

TOUR Notes

Master Dimmer

Red, Green, Blue, and
White Color Selection

Color Macros

Strobe

ID Address Selection

Auto

Dimmer Speed

COLORado™ 1 Tour User Manual Rev. 01h
These notes intent to clarify the way the TOUR DMX personality works.
• Channel 1 controls the intensity of the currently projected color.
• When the slider is at the highest position (255) the intensity of the output is at its
maximum
• Channels 2, 3, 4, and 5 control the intensity ratio of each of the Red, Green, Blue,
and White LEDs
• When the slider is at the highest position (255), the intensity of each color is at its
maximum
• You can combine channels 2, 3, 4, and 5 to create over four billion colors
• Channel 6 selects the required Color Macro
• Channel 6 has priority over channels 2, 3, 4, and 5
• Channel 1 controls the intensity of the Color Macro
Channel 7 controls the strobe frequency (not the intensity) of channels 2~6
Strobe 1 is with RGB in-step
Strobe 2 is with RGB out-step
Strobe 3 is a pulse strobe(fast on/slow off)
Strobe 4 is a pulse strobe (slow on/fast off)
Channel 7 strobes channels 2, 3, 4, and 5 when not running macros, allowing the
individual faders (R, G. B, and W) as well as channel 1 (D) to control the output
intensity
Channel strobes channel 6 when running macros, allowing channel 6 to select the
macro and channel 1 to controls the output intensity
• Channel 11 selects the target ID address
• Each independent DMX address may have up to 66 independent ID addresses
• An ID address of 0 will activate all ID address locations
• Channel 8 selects the preset Auto programs AT. 01~10 or the custom Auto
programs CUS. 01~10
• When activating the custom Auto programs CUS. 01~10, it is possible to control
the Step Time and Fade Time using channels 2 and 3 respectively
• Channel 8 has priority over channels 2, 3, 4, 5, 6, and 7
• Channel 9 is for selecting the dimmer mode and speed. When Dimmer is set to
Off, the Red, Green, Blue, White, and Dimmer outputs are linear with the faders.
Otherwise, Dim1 is the fastest dimmer curve, while Dim4 is the slowest.
Operation
-13-

Advertisement

Table of Contents
loading

Table of Contents