Installation - saro GTK 600 PRO Manual

Do not cover or block the air openings.
• Do not tilt the unit more than 45 degrees.
• Before connecting to your mains, check that the type of current and mains voltage correspond to the specifications on the
type plate. Commissioning is only possible if they match in order to avoid accidents/defects.
• Do not use adapters, power strips and/or extension cords; otherwise the cables/lines can quickly overheat if other appliances
are also connected. The risk of fire increases.
•
Do not move the unit during use.
•
Before moving the unit, switch it off (if there is a switch for this purpose) and disconnect the mains plug.
•
Always pull the cable out of the socket by the plug housing only.
•
Make sure that the unit does not tilt when moving. This could lead to injuries.
•
When the unit is back in place, wait 2 hours before operating the unit again.
•
A longer transport causes a standstill time of approx. 24 hours before commissioning in order to avoid unit damage/accidents
as a precaution.
•
After a possible power failure or a short unplugging, switch off the unit briefly, wait 5 minutes, plug in again and start the unit.
•
Do not let the mains cable hang over sharp edges, do not crush it and keep it away from hot objects and open flames.
• Make sure that it is not possible to accidentally pull on the cable or trip over it.
• Check the cable regularly. If it is damaged, e.g. by crushing, then it must be replaced by a qualified specialist.
•
Do not touch the appliance, cable or plug with wet or damp hands.
•
Caution! The unit is live as long as it is connected to the mains.
• Protect the unit from moisture.
• Do not clean the appliance with an open jet of water.
•
Do not immerse the unit in water or other liquids or wet it with liquids.
If the appliance should get wet, unplug it from the mains immediately and have it checked by a specialist before using it
again. There is a danger to life from electric shock.
•
A damaged unit must not be used!
In this case, disconnect the unit from the mains and contact your specialist dealer!
•
Never attempt to open or repair the unit yourself. There is a danger to life!
•
Do not touch the compressor, it could cause burns.
•
Do not drill or pierce a hole in the unit, either from the outside or inside.
Do not install any other appliances on the cooling unit or place any foreign objects there.
•
Do not interfere with the cooling circuit! This is the responsibility of a specialist!
Refrigerants R600a, R290 are very environmentally friendly - but are colourless, almost odourless, flammable gases; heavier
than air; narcotic and suffocating in high concentrations!
•
Repairs must be carried out by appropriate specialists using the original spare parts.
•
Always disconnect the appliance from the mains before cleaning, and also if it is not going to be used for a long time.

INSTALLATION

Place the appliance in a dry and adequately ventilated room, ensuring it stands securely on a dry and non-slip surface.
Position the appliance with the back at least 10 cm away from the wall to ensure sufficient air circulation at all times. Leave a
minimum of 30 cm of space above the appliance and 10 cm on each side.
The performance and power consumption may be affected by ambient temperature or direct sunlight. Therefore, do not expose the
appliance to direct sunlight and avoid placing it near a stove, radiator, or any other source of heat.
Ensure that the power plug is always easily accessible and can be disconnected from the power supply without difficulty.
Arrange the appliance's shelves so that the spacing matches the height of your goods.
After delivery or transport of the unit, connect it only after the unit has been at rest for at least 24 hours. This
is absolutely necessary so that the refrigerant can collect in the compressor.
Seite 21 von 29
07/23 SvN