Advertisement
Quick Links
LIMIT
Basin Mono No Pop-Up Waste
i
IMPORTANT INFORMATION BEFORE YOU START
Please read carefully and keep this information for further reference.
All products manufactured and supplied by
Crosswater are safe provided they are installed, used
correctly and receive regular maintenance in accordance
with these instructions. If you are in any doubt about your
ability to install this product safely you must employ the
services of an experienced qualified plumber.These fittings
need to be installed in accordance with, and meet the
requirements of the Water Supply (Water Fittings)
Regulations 1999 and Scottish Byelaws 2004.
Operating pressure range: Minimum 0.2 bar, Maximum 5.0
bar. Maximum static pressure: 10.0 bar.
Note: Nominally equal (balanced) inlet supply pressures are
recommended for optimum performance with mixer taps.
1
Designed to comply with BS EN 200 for single taps
/combination taps and BS EN 817 for single lever mixers, for
water systems of type 1 and 2 general technical specifications
and to be used within systems designed to BS 6700. BS 6700
recommends the temperature of stored water should never
exceed 65°C.
meet all normal requirements and will minimise the build up
of lime scale in hard water areas. If the fitting is installed at
low pressure (tank fed), then the minimum distance from the
highest installed position of the outlet to the underside of the
cold tank should be at least 2 metres to ensure adequate
performance.
PRODUCT CODES:
LI110DNC
LI110DNF
LI110DNM
V10423
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Crosswater Limit LI110DNC
Summary of Contents for Crosswater Limit LI110DNC
- Page 1 All products manufactured and supplied by Designed to comply with BS EN 200 for single taps Crosswater are safe provided they are installed, used /combination taps and BS EN 817 for single lever mixers, for correctly and receive regular maintenance in accordance water systems of type 1 and 2 general technical specifications with these instructions.
- Page 2 DIMENSIONS NOTE: ALL DIMENSIONS IN MILLIMETRES IMPORTANT INFORMATION Please read carefully and keep this information for further reference. These taps and mixers should be installed in compliance with the Water Regulations. Where the supplies are unbalanced, i.e. Hot water from cylinder tank / cold from the mains, approved check valves must be fitted in the supply pipes.
- Page 3 INSTALLATION INSTALLATION tighten. Place mixer in position to see if any alteration to any necessary alterations to the pipework, pass the mixer through the hole in the basin from above and place the mixer in position on the basin. Slide the C-shaped black washer and then the metal Check that the mixer body is correctly positioned to the but do not over tighten as damage may be caused to the sink.
- Page 4 CARE & MAINTENANCE CLEANING THE CARTRIDGE The concealed cartridge should give trouble free service, but in the event of any problems, servicing is straight forward. To remove the cartridge: ALLEN KEY With an hexagonal key loosen the screw, but do not remove HANDLE it.
Need help?
Do you have a question about the Limit LI110DNC and is the answer not in the manual?
Questions and answers