Crosswater Arcade US-ARCV17 Installation Instructions

Arcade Air Boost Rain Heads
US-ARCV17
US-ARCV60
Installation Instructions

Introduction

This shower head is suitable for use with all water systems up to a
maximum operating pressure of 72 psi, beyond which pressure-
reducing valves must be installed. The minimum water pressure
requirement is 3 psi.
The shower head has been fully inspected throughout the production
process and only leaves our factory after a 15-step QC process.
Carefully remove the shower head from the box and check that all
parts have been supplied.
Before beginning installation, please check for any damage that may
have occurred during transport. Note: Damage claims cannot be
made during or after installation.
Improper installation shall result in loss of warranty in case of damage
caused by impacts or rubbing against rough surfaces.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.

Installation notes

The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
IMPORTANT! Before installing a new shower head it is essential that
the supply lines are thoroughly flushed in order to remove any
remaining debris, solder or other impurities. Failure to carry out
this simple procedure can cause problems or damage to the
function of the shower head.
Installing shut-off valves on incoming supply lines is recommended
for ease of maintenance.
Turn off the main water supply before connecting to any existing
pipe work or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise before drilling holes in a wall or floor.

Tools required

Channel
locks
Plumbers' putty Adjustable
or caulking wrench

Dimensions

9" shower head
13" shower head
Flat head
screwdriver
8-1/8"
9-1/4"
G 1 / "
2
11-3/4"
13"
G 1 / "
2
Cross head Hexagonal
screwdriver key