Advertisement
Installing Speed Handle
1. Install the Speed Handle (17) by threading handle
into the opening on left side of the Drill Press.
Feed Handles/Bars
Thread the Feed Bars (122) into the
Feed Bar Seat (10) and tighten them.
Installing/Removing the chuck
1. Thoroughly clean the Arbor (64) and the tapered
hole in the Chuck (65) of all dirt, grease, oil,
and protective coatings. Make sure all parts
are thoroughly clean, dry and burr free.
2. Insert the Arbor into the end of the
Spindle (63). If necessary, rotate the Arbor
to ensure that it is correctly positioned and
fully inserted into the Spindle shaft. Firmly
tap the Arbor nose with a rubber mallet.
3. Open the jaws of the Chuck to their
maximum, using the supplied Chuck Key.
4. Slide the Chuck onto the Arbor
nose as far as it will go.
Item 58781
For technical questions, please call 1-888-866-5797.
Speed Handle (17)
5. Hold a piece of scrap wood against the Chuck
nose to protect it and firmly tap the wood with
a rubber mallet to ensure proper seating and
a solid fit of the Chuck on the Spindle.
6. To remove the Chuck, use Feed Handles to
lower Chuck until slots in Quill and Spindle
are exposed. Rotate chuck until they align.
7. Adjust the lower Stop Nut all the way
up to lock Spindle in place.
8. Slide Wedge (130) into the slot and tap it with
a rubber mallet (not included) to release the
Chuck and Arbor. Make sure to hold chuck
with one hand to prevent it from falling.
Feed
Handles (17)
Feed Bar
Seat (10)
Feed Bar (122)
Page 7
Advertisement
