Advertisement
General Operating Instructions
1. Bring the drill bit down with the Feed Knob to where
the hole is to be drilled.
Make minor workpiece alignment adjustments.
2. Plug the Power Cord into an electrical outlet.
3. Turn the Drill Press on.
4. Move speed lever to appropriate
setting (see table on page 9).
5. Pull down on the Feed Knob and slowly
drill the hole into the workpiece.
6. Turn Drill Press off by flipping Power Switch down.
Item 58781
For technical questions, please call 1-888-866-5797.
7. To lock Drill Press in the OFF position,
remove the safety key from Power Switch and
store key in a safe place until next use.
WARNING! TO pREVENT SERIOUS INJURy: If
the drill bit grabs and spins the workpiece, do not
attempt to stop the spinning with your hands. Step
back, and turn the drill press off. Wait for the spindle
to stop turning before dislodging the workpiece.
8. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children's reach.
Page 11
Advertisement
