Advertisement
Quick Links
UM_2203_PL32_2204_092120
Quick start guide
Rapid IoT Connect developer kit with CYSBSYS-RP01
system-on-module and OPTIGA™ Trust M security controller
CYSBSYSKIT-DEV-01
Chip antenna (A1)
User button (USR_BTN)
Header compatible with
Adafruit Feather (J1)
Reset button (RST)
Battery connector (J3)
KitProg3 status LED (Yellow – LED3)
User LED (Red – LED2)
Kit contents
• CYSBSYSKIT-DEV-01 board
www.infineon.com/CYSBSYSKIT-DEV-01
CYSBSYSKIT-DEV-01 board top view
CYSBSYS-RP01 module
Micro-B USB connector (J4)
17.2032-MHz ECO (Y1)
JTAG header*
Header compatible with
Adafruit Feather (J5)
3.3-V regulator (TPS7A2533DRVR - U15)
Power LED (Blue – LED4)
Charging indicator LED (Yellow – LED5)
Advertisement
Related Manuals for Infineon CYSBSYSKIT-DEV-01
Summary of Contents for Infineon CYSBSYSKIT-DEV-01
- Page 1 UM_2203_PL32_2204_092120 Quick start guide Rapid IoT Connect developer kit with CYSBSYS-RP01 system-on-module and OPTIGA™ Trust M security controller CYSBSYSKIT-DEV-01 CYSBSYSKIT-DEV-01 board top view CYSBSYS-RP01 module Chip antenna (A1) 17.2032-MHz ECO (Y1) User button (USR_BTN) JTAG header* Header compatible with Adafruit Feather (J5)
- Page 2 * Footprint only; not populated on the board. IMPORTANT: CYSBSYSKIT-DEV-01 Rapid IoT connect developer kit is sensitive to ESD. Hold the board only by its stack-up headers. After removing the board from its box, place it on a grounded, static-free...
- Page 3 Quick start guide Before you start Kit with pin mapping 1. Ensure that you have the following: • PC with USB port • UART terminal software such as Tera Term or Minicom • USB cable with Micro-B connector at one end P6_1/SDA P5_3/CS P6_0/SCL...
- Page 4 SPI Master In / Slave Out (MISO P6_4 J5.14 UART RX Connected to KitProg3 P6_5 J5.15 UART TX Connected to KitProg3 P5_3 GPIO14 J5.16 SPI CS SPI Chip Select Document number: 002-30996 Rev. *B Date: 03 / 2022 All rights reserved. © 2022 Infineon Technologies AG...