TVS Jupiter BS-V1 Owner's Manual page 56

FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main causes for fuse failure.
There are two fuse cases containing three blade type
fuses (15A x 1 and 10A x 2) located near the battery.
Follow the procedure given below for inspecting and
replacing the fuse.
1. Turn 'OFF' the ignition.
2. Remove the front panel as explained earlier.
3. Take out the fuse cases one by one near from
the battery.
4. Open the fuse cases and take out the fuses.
50
5. Inspect the fuse for failure. If found defective,
replace the fuse with a new (extra fuse provided
in the wiring harness itself in a pouch or provided
inside the fuse case itself).
6. Close the fuse case and re-fix it into the battery
box.
7 . Turn 'ON' the ignition switch and check for proper
functioning of electrical systems. Incase the
fuse fails again, consult the nearest TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
Good Fuse
Do not use vehicle by shorting the wires without
fuse. This may result in overheating of electrical items
/ wiring and may result in fire. Do not use fuse of higher
amperage than specified for the safety of electrical
system.
Blown Fuse