Table of Contents
Advertisement
15 - ACTUATOR WIRING
15.1 - 1050 Control Board Wiring (Single and Dual Gate Application)
15.1.1 - 816 ACTUATOR WIRING (PULL TO OPEN)
816 limit switch and smart sensor wiring
Connect the Nice 816 actuator cable to the 5-pin connector
as shown below. These connections enable the Nice 816 limit
switch and smart sensor inputs into the gate controller.
Nice actuator motor wiring
Connect the Nice 816 actuator motor leads to the 3-pin
connector as shown below.
Note: If the gate moves in the opposite direction from what
is expected, reverse the actuator wiring from what is shown.
(Red to Pin 1, Black to Pin 3).
Install the 5 and 3-pin connector into the connection labeled
"Motor 1" on the controller. Install the 5 and 3-pin and
connector into the connection labeled "Motor 2" for a dual leaf
swing gate installation. For dual actuators, the actuator with the
shorter cable must plug into Motor 1 connections.
816 ACTUATOR SINGLE MOTOR - PULL TO OPEN
WHITE: Extend Limit
816 ACTUATOR
ORANGE: Retract Limit
(with encoder)
GREEN: Limit Common
YELLOW: Encoder Signal
BLUE: Encoder Power
DO NOT USE
816 ACTUATOR
MOTOR LEADS
816 ACTUATOR DUAL MOTOR - PULL TO OPEN
BLUE
YELLOW
816 ACTUATOR
GREEN
(with encoder)
ORANGE
WHITE
DO NOT USE
816 ACTUATOR
BLACK
MOTOR LEADS
RED
MOTOR 1
19
BLUE
YELLOW
GREEN
ORANGE
WHITE
BLACK
RED
MOTOR 1
WHITE
ORANGE
816 ACTUATOR
GREEN
(with encoder)
YELLOW
BLUE
WHITE: Extend Limit
ORANGE: Retract Limit
GREEN: Limit Common
YELLOW: Encoder Signal
BLUE: Encoder Power
816 ACTUATOR
RED
MOTOR LEADS
BLACK
MOTOR 2
15.1.2 - 816 ACTUATOR WIRING (PUSH TO OPEN)
816 limit switch and smart sensor wiring
Connect the Nice 816 actuator cable to the 5-pin connector
as shown below. These connections enable the Nice 816 limit
switch and smart sensor inputs into the gate controller.
Nice actuator motor wiring
Connect the Nice 816 actuator motor leads to the 3-pin
connector as shown below.
Note: If the gate moves in the opposite direction from
what is expected, reverse the actuator wiring from what is
shown. (Red to Pin 1, Black to Pin 3).
Install the 5 and 3-pin connector into the connection labeled
"Motor 1" on the controller. Install the 5 and 3-pin and
connector into the connection labeled "Motor 2" for a dual
leaf swing gate installation. For dual actuators, the actuator
with the shorter cable must plug into Motor 1 connections.
816 ACTUATOR SINGLE MOTOR - PUSH TO OPEN
WHITE: Extend Limit
816 ACTUATOR
ORANGE: Retract Limit
(with encoder)
GREEN: Limit Common
YELLOW: Encoder Signal
BLUE: Encoder Power
DO NOT USE
816 ACTUATOR
MOTOR LEADS
816 ACTUATOR DUAL MOTOR - PUSH TO OPEN
BLUE
YELLOW
816 ACTUATOR
GREEN
(with encoder)
WHITE
BLUE
DO NOT USE
816 ACTUATOR
MOTOR LEADS
BLACK
MOTOR 1
BLUE
YELLOW
GREEN
WHITE
ORANGE
RED
BLACK
MOTOR 1
ORANGE
WHITE
816 ACTUATOR
GREEN
(with encoder)
YELLOW
BLUE
WHITE: Extend Limit
ORANGE: Retract Limit
GREEN: Limit Common
YELLOW: Encoder Signal
BLUE: Encoder Power
816 ACTUATOR
BLACK
MOTOR LEADS
RED
MOTOR 2
Advertisement
Table of Contents
