Table of Contents
Advertisement
EON315 Specifications
System Type:
Frequency Range (-10 dB):
Frequency Response (±3 dB):
Coverage Pattern:
Directivity Index (DI):
Directivity Factor (Q):
Crossover Frequency:
System Power Rating:
LF Power amp:
HF Power amp:
Distortion:
Maximum SPL:
Signal indicators:
Input Gain:
Input Impedance:
Boost EQ:
Low Cut Filter:
LF Driver:
HF Driver:
Input connector:
Output connector:
XLR Pin Assignments:
Limiting/Protection:
Enclosure:
Handles:
Suspension / Mounting:
Grille:
AC input
Dimensions (H x W x D):
Net Weight:
Block Diagram
OUT
INPUT
LEVEL
LINE
MIC
MIC
Self powered 15", two-way, bass-reflex design
38 Hz - 20 kHz (EQ in 'Flat' position)
50 Hz - 18 kHz (EQ in 'Flat' position)
100º x 60º nominal
9 dB
8
1.8 kHz
280 W continuous, 560 W peak
220 W continuous at driver impedance
60 W continuous at driver impedance
Less than 0.1% at rated power
127 dB
Limit: Red LED indicates input overload condition
Signal: Green LED indicates signal present
Mic/Line: Red LED indicator
Mic position: - infinity to +40 dB
Line position: -infinity to +4 dB (+20 dBu Max signal input)
64 K Ohms (balanced), 32 K Ohms (unbalanced)
LF +3 dB Shelving Filter @ 150 Hz
HF +2.5 dB Shelving Filter @ 4 kHz
Preset high pass @ 120 Hz
1 x M115-2 380 mm (15 in)
1 x JBL 2414H-1 25.4 mm (1 in) polymer diaphragm, neodymium compression driver
Balanced XLR / ¼ inch TRS combo jack.
Balanced male XLR, +20 dBu (peak) o/p level
Pin 2(+), Pin 3(-), Pin 1(GND)
Dynamic Limiter
PP impact copolymer, multi-purpose main & monitor orientation.
One left/right side, one on top
36 mm pole socket with stabilizing screw, 4 x M10 suspension points,
1 x M10 pull-back point.
Powder coated perforated steel with acoustically transparent black screen backing.
120 – 240 v, 50/60 Hz
685 x 438 x 366 mm ( 27 x 17.3 x 14.4 in)
15.9 kg (35 lb)
LIMIT
EQ
BOOST
FLAT
CUT
SIGNAL
HPF
HF
LPF
LF
11
Advertisement
Table of Contents
