Advertisement
Place the tweeter in the mounting location, then turn each setscrew clockwise to tighten mounting brackets. Use caution so
as not to overtighten. Snap the included outer ring over the mounting bracket to hide the setscrews.
-
-
-
Specifications
Kappa&
Kappas
Kappa 10
Continuous power
100W
200W
300W
handling
Peak power handling
300W
500W
900W
Frequency response
40Hz-25kHz
30Hz-22kHz
20Hz-2kHz
Nominal impedance
3 Ohms*
3 Ohms*
2 or 4 Ohms (use
switch to select)
Sensitivity
92d8
92d8
89d8
External diameter
7-15/32" (189.4mm)
9-1 /2" (241 mm)
11-5/8" (295mm)
Mounting cutout diameter
5-23/32" (144.8mm)
Woofer: 7" (177.4mm)
9-9/16" (235.6mm)
Tweeter bracket: 4-9/16"
(115.9mm)
Total depth
3-21/32" (92.5mm)
4-9/32" (108.1 mm)
6-13/32"
(162.4mm)
Mounting depth
2-9/16" (65mm)
3-3/16" (80.5mm)
4-7 /8" (123mm)
-
*NOTE: Because of the woofer's low impedance, do not wire two or more in parallel to an amplifier; doing so can result in
overheating and damage to the amplifier.
~
HARMAN
~
HARMAN
International Industries,
Incorporated 8500 Balboa Boulevard,
Northridge, CA 91329 USA
www.infinityspeakers.com
@
2018 HARMAN International Industries, Incorporated. All rights reserved.
Infinity is a trademark of
HARMAN
International Industries, Incorporated,
registered in the United States and/or other countries. Features, specifications
and appearance are subject to change without notice.
Advertisement
